Bleuchez!

This clock was something I decided to make after I saw this binary clock at ThinkGeek. I figured I could customize it by putting in a decimal display as well as a temperature sensor. Why pay somebody for something when you can build something 2x better for 4x the cost?

The clock is driven by an Atmel ATmega32 microprocessor. The binary display is driven by 20 LEDs, the decimal display has five 7-segment displays. 4 displays give hours and minutes, the last displays A or P to denote AM or PM. The decimal displays are driven by one MC14489BP display driver. A screen shot of the PCB is shown below. The PCB has a programming port compatible with an AVR-ISP built in so the MCU may be programmed.

The source code is written in C and can be compiled using the AVR-GCC compiler and uploaded to the MCU via an AVR-ISP. The temperature sensor has been wired up on the board but I did not finish writing code for it. The code given below will drive the binary and decimal displays.

Downloads

Everything below is yours to use as you please. I am not responsible for any problems you encounter. This code worked fine when I built the circuit on a beadboard. However, you may contact me and I will try my best to help.

1) C code for the clock.

2) Express PCB layout for the clock.

3) Parts list.

The clock is driven by an Atmel ATmega32 microprocessor. The binary display is driven by 20 LEDs, the decimal display has five 7-segment displays. 4 displays give hours and minutes, the last displays A or P to denote AM or PM. The decimal displays are driven by one MC14489BP display driver.